LIVE

There isn't a kitten that wouldn't purr over a catnip-filled knitted pillow. The toys are also packed with wool stuffing and a jingle bell.

Updated July 12, 2019
Read step by step instructions after the video.

This toy is a great way to use leftover yarn because it requires less than an ounce. You'll also need a handful of wool stuffing, a large needle, a jingle bell, and a couple of spoonfuls of dried catnip.

Abbreviation Key:

St= StitchK= KnitKFB= Knit into front and back of stitch (to make 2 stitches where there was 1)P= PurlK2Tog= Knit 2 stitches togetherP2Tog= Purl 2 stitches togetherBO= Bind off

We used chunky-weight yarn and size-11 needles to make a 3-inch-wide heart. Using different yarn weights and needles will produce results in a variety of sizes. The instructions use standard knitting abbreviations; refer to the key for clarification.

Advertisement

What you need

Materials
Advertisement

How to do it

Part 1

Step 1

Cast on 2 St.
Row 1: KFB, K to last St, KFB.
Row 2: P.
Repeat these 2 rows until there are 14 St (12 rows total).

Advertisement
Step 2

Row 13: K2Tog, K5, and turn work; leave remaining 7 St on needle. Row 14: Working with the 6 St closest to end of needle, P2Tog, P2, P2Tog. Row 15: BO 4 Sts, and trim remaining yarn to 24 inches. Use large needle to weave yarn through back of piece to beginning of reserved 7 St. Row 16: Working with reserved 7 St, K5, K2Tog. Row 17: P2Tog, P2, P2Tog. Row 18: BO 4.

Step 3

Using a large needle, weave loose ends of yarn into back of heart.

Advertisement
Step 4

Repeat knitting instructions above to make a second heart.

Advertisement
Step 5

Stack hearts with right sides out. Using a mattress stitch and a needle threaded with yarn, sew hearts together along perimeter, leaving a 1-inch gap.

Step 6

Tuck half the stuffing inside heart, and insert a bell and catnip. Add remaining stuffing to fill heart.

Advertisement
Step 7

Sew closed the 1-inch gap in the heart pillow, and weave yarn up inner side of heart. Trim excess yarn at edge of heart so that the loose end is hidden inside.

Comments

How difficult was this project?
Be the first to comment!

Project Toolbar

Font Size