New This Month


Hanukkah-Brilliance Menorah

Photography: Ryan Liebe

Source: Martha Stewart Living, December/January 2015


  • Red-oak block, cut to 10 by 3 inches (3" by 3" by 36", $22,

  • Clamp

  • Drill and 7/16-inch spade bit

  • Painters’ tape

  • Fine-grit sandpaper

  • Oak hobby board, cut to 10½ by 3 inches (1/4" by 3" by 36", $4,

  • Whitewash pickling stain, such as Minwax

  • Metal snips

  • Copper spray paint (by Montana, in Copperchrome, $7.75,


  1. Mark 9 spots down center of oak block, each 1 inch apart.

  2. Clamp block to work surface. To make hole for shamash candle, measure bit 3/8 inch from tip and mark with painters’ tape. Drill bit into middle (fifth) mark until it reaches tape. Remove tape from bit.

  3. Measure bit 5/8 inch from tip and mark with painters’ tape. Drill remaining 8 holes, using new tape as guide.

  4. Sand block and hobby board. Stain, following package instructions; let dry completely.

  5. With snips, cut two 10 1/2-inch and two 3-inch pieces of brass strip. Spray-paint brass pieces. Using adhesive, glue strips to edges of hobby board, then glue block to hobby board.

  6. Insert copper couplings in holes.

Reviews Add a comment