Tools and Materials
Wrapping paper
Scissors
4-inch by 4-inch squares or 4-inch-diameter circles of plexiglas or glass
Utility knife and board to cut on
Mod Podge glue sealant
Sponge brush
Cork with adhesive backing/shelf tiling
Bone folder
Ribbon
Martha's Famous Eggnog recipe card

Gift-Wrap Coasters How-To
1. Cut out a piece of paper slightly larger than the glass square. You can use any type of wrapping paper, or nice-looking kraft paper.

2. Apply Mod Podge solution with sponge brush lightly to one side of the glass -- brushing from the center out.

3. Place your paper face down onto the glued side. Smooth paper to glued side with bone folder -- make sure to remove all air bubbles.

4. Let stand until it's completely dry. If you mess up on the glue or paper, don't fret -- just wipe off the glue and start over.

5. Trim off excess paper with a utility knife.

6. Peel off adhesive side to cork square, and attach to papered side of glass. Trim excess cork with a utility knife.

7. Tie four coasters together with decorative ribbon, and add a recipe card for Martha's Famous Eggnog.

Resources
Adhesive cork liner is available from the Container Store.

Mod Podge, bone folders, and plexiglass squares can be found at any craft store, or online at michaels.com or artsuppliesonline.com.