1 of 6
This bat pinata, created using the technique of papier-mache, is creepy enough to be the center of your party decorations. Just be careful after dark; he might swoop down and give you a fright.
Tip: When using black tissue paper, wear gloves and cover your work surface because the dye may run and stain.
What You'll Need:
- Balloons Jars Craft glue, by Martha Stewart Crafts
- Black tissue paper, from Create for Less
- Medium artist's paintbrush
- Clothespins and clothesline
- Small scissors, by Martha Stewart Crafts
- Craft knife, by Martha Stewart Crafts
- White card stock, by Martha Stewart Crafts
- Black poster board
- Bat face template
Photography: Jose Manuel Picayo Rivera2 of 6
Step 1: Paste Layers of Tissue Paper on Balloon
Begin by resting a large balloon on an empty jar (this will prevent the damp tissue from discoloring or sticking to the work surface). Dab diluted craft glue (2 parts glue to 1 part water) on a small section of the balloon, and cover with two full layers of newspaper. For each strip of paper, apply glue and overlap each one slightly before brushing on more glue. After the second layer, tie a long piece of string around center (this will hang your pinata), then continue with 2 more layers of newspaper, followed by black tissue, from the balloon's crown to its knot. Repeat for small balloon (this will become the bat's head), but don't include the string.
Note: This picture is meant to illustrate the technique, but you will be using newspaper and black tissue paper, rather than orange tissue paper, for this project.
3 of 6
Step 2: Hang to Dry
Using clothespins, hang the tissue-covered large and small balloons from the clothesline by their knots; let dry completely (several hours or overnight).
4 of 6
Step 3: Cut Hole for Candy
Cut a hole in top of body (the large balloon) with utility knife, and save the piece to use for ears. Pop the balloon by making a slit with scissors next to the knot; remove. Cover cut edge with tissue and fill the body with wrapped candy.
5 of 6
Step 4: Assemble the Bat
Pop and remove the balloon from smaller piece. Place small sphere (the head) onto large one (the body). Drape several layers of black tissue paper over the head toward the body and around the neck, brushing with diluted glue until neck is secure. Let dry. Draw or print our bat face template; trace onto white card stock. Cut out features; attach with undiluted glue. Cut ears from reserved piece; glue in place.
Swipe here for next slide
6 of 6
Step 5: Make the Wings
Sketch large wing shapes on black poster board, and cut them out. Secure wings to the sides of the bat's body with black duct tape. Paste black tissue paper over the joints to cover the tape. Next, use tape to attach a length of string to the end of each wing. (This will allow you to suspend the wings as if in flight.) Cover the tape with tissue paper. To hang the bat, suspend from body string. Then, tack the two wing strings to the ceiling to make the bat look as if it is flying.