Sequin Cuff Bracelet
- Bias leather tape, approximately 1 inch wide and 7 1/2 inches long
- Multi-row sequin trim, 3/4 inch wide and approximately 7 1/2 inches long
- Magna Tac, or other fast-drying fabric glue
- Metallic cord
- Metal button
- Needle and thread
Measure leather tape around your wrist, adding 1/2 inch on either side to accommodate the button closure; trim excess.
Trim the length of sequin trim to the same size as the tape.
Apply a thin line of Magna Tac along each edge of the leather tape. Press the sequin trim into place; let dry.
Fold a cuff about 1/2 inch from front to back for the button side of the closure; apply glue and press into place.
Cut a short piece (approximately 1 1/2 inches) of metallic cord to make the loop closure. On the opposite end of the tape, glue the ends of the cord to the back of the tape and fold a cuff over it from front to back. Glue to secure; let dry.
Once glue is dry, sew button to opposite edge of the tape.