advertisement

advertisement

No Thanks
Let
Keep In Touch With MarthaStewart.com

Sign up and we'll send inspiration straight to you.

Martha Stewart takes your privacy seriously. To learn more, please read our Privacy Policy.

Project

Lantern-o'-Treats

Get double duty out of your jack-o'-lantern by using it as a glowing candy bowl.

Introduction

Choose a large pumpkin, and find a jar that will fit inside.

Steps

  1. Step 1

    Remove the pumpkin's stem, and trace the bottom of the jar on the top of the pumpkin. Following this outline, cut the top off the pumpkin, making the hole slightly larger than the outline to allow easy jar entry. Scrape out seeds and innards, thinning rind to about 1 inch thick, and, with a small keyhole saw, cut a jagged edge into the top of the pumpkin.

  2. Step 2

    a98111_1000_ht_2.jpg

    By hand or computer, print the word TREATS on paper, and tape to the side of the pumpkin. Use a pin or needle tool to prick a dot outline of your design onto the pumpkin.

  3. Step 3

    a98111_1000_ht_3.jpg

    Remove paper, and with a linoleum cutter, scrape out the skin inside the outline, at least 1/8 inch deep.

  4. Step 4

    a98111_1000_ht_4.jpg

    Now attend to your jar: With scissors, cut a jagged design along the long edge of a strip of crepe paper, and, gathering it, attach it below the rim of the jar with masking tape. Wind a strand of Christmas lights around the jar, carve a hole in the back of the pumpkin to pass the cord through, and slide the jar in the pumpkin. Fill the jar with candy; once you've plugged in your pumpkin, it will take on a festive glow.

Source
Martha Stewart Living, October 2000