Close

Project

Make a Plant Stand

This elegant, handcrafted stand is an excellent way to display your plants.

Make a Plant Stand

Source: The Martha Stewart Show, January 2010

materials

  • 3/4-inch medium-density fiberboard (MDF)

  • 3-foot piece of one-by-one wood (poplar or pine)

  • Double-sided tape or spray adhesive

  • Clamps

  • Worktable or sawhorse

  • Jigsaw

  • 7 8-inch round plaques

  • Ruler

  • Pencil

  • Wood glue

  • Drill

  • Countersink drill bit

  • Box of 1 5/8-inch wood screws

  • Wood putty

  • Sandpaper

  • Primer and paint

steps

  1. Print arm/leg template and affix to a piece of MDF with tape or spray adhesive. Clamp MDF to a worktable or sawhorse. Cut the template shape from MDF with a jigsaw. Repeat this step 10 times to make enough pieces for a six-armed and four-legged plant stand.

  2. Center the flat 2 1/4-inch end of one arm on the front side of one plaque. Trace around the end with a pencil. Mark two points for screw holes within this rectangle, then drill pilot holes with a countersink drill bit through top of plaque. Spread wood glue on end of arm; secure in place on underside of plaque by drilling a screw through each pilot hole. Fill countersink hole with wood putty, allow to dry, and sand. Repeat to make six arms with attached plaques.

  3. Attach seventh plaque to an end of the 3-foot one-by-one wood piece (the stand "body") in the same way.

  4. On the other end of the one-by-one, attach the 4 1/2-inch end of each of the four legs to each side of the one-by-one. Mark and drill pilot holes with a countersink bit first, drilling at an angle through the curve of each leg. Place each leg against one side of the one-by-one, flush with the bottom, and secure with wood glue and two screws.

  5. Add two arms in the same way, opposite each other on the one-by-one wood piece, 2 inches above the top of the legs. Add a second set of two arms, 9 inches above and perpendicular to the first set. Add a third set of two arms, directly above and perpendicular to the second set.

  6. Fill all screw holes with wood putty, allow to dry, and sand. Prime and paint stand desired color.

Reviews

Be the first to comment!

Related Topics