No Thanks
Let

Keep In Touch With MarthaStewart.com

Sign up and we'll send inspiration straight to you.

Martha Stewart takes your privacy seriously. To learn more, please read our Privacy Policy.

Project

Felt Frame Cover

Using felt in a range of complementary colors, you can transform a self-standing clear Lucite frame into a wonderful gift or keepsake.

Introduction

Three colors of felt -- for the frame's front, back, and edging -- will produce the best decorative touch. Or, you can use leather for a more sophisticated look. If you choose leather, stick to one color, forgo trim, and assemble the cover with a sewing-machine needle intended for leather. Make sure to use a frame whose borders are wide enough for decorating; for a 4-by-6-inch photo, use a frame that is at least 5 by 7 inches.

Materials

  • Lucite frame
  • Felt
  • Pencil
  • Pinking shears
  • Paper
  • Rotary cutter or small scissors
  • Fabric glue
  • Sewing machine

Steps

  1. Step 1

    Lay the frame on the piece of felt that will cover the front borders of your frame. Align the bottom of the frame with the bottom edge of the felt, then trace along the top edge and two side edges 1/2 inch away from the frame. Cut along the pencil marks with pinking shears.

  2. Step 2

    Determine the size of the opening that will expose your picture. (Imagine a traditional frame.) To create a template for the opening, center your photograph on a piece of paper cut to the size of the front cover. Cut out the template, making it slightly smaller than the actual photograph so its edges won't show.

  3. Step 3

    To make the edging, cut four 1-inch-wide strips, each slightly longer than the four corresponding sides of the opening. Pink one side of each strip. Use craft or fabric glue to glue the strips to the back of the opening. Leave about 1/4 inch of the pinked edge protruding from the opening.

  4. Step 4

    The corners of your strips will overlap a bit. Trim them at 45-degree angles with scissors so that they are mitred. This will allow the corners to lay flat.

  5. Step 5

    Lay the front cover on a slightly larger piece of felt (about 1/2 inch bigger on all sides than your front piece). This piece will cover the back of your frame. Pin the front cover to the back cover, and sew around the top and the sides, leaving the bottom open. Use a 1/4-inch seam allowance. The edge of your presser foot can serve as a guide. Make sure the top thread color matches the top layer, and the bobbin matches the bottom layer.

  6. Step 6

    Trim the back layer with pinking shears, leaving about 1/4 inch exposed as a decorative edge.

  7. Step 7

    Trim the bottom back edge so it is slightly shorter than the front. This will help the cover lie flat against the frame without buckling.

  8. Step 8

    Slip the cover onto the frame.

Source
Martha Stewart Living Television