Project

Monogrammed Slippers

Children will especially adore their personalized pairs, but you can personalize these snuggly slippers to suit any recipient.

Monogrammed Slippers

Photography: Christopher Baker

Source: Martha Stewart

Introduction

Covered buttons with delicate lowercase letters (left, top) are embroidered in a satin stitch. Felt patches with satin-stitched initials (left, middle) are tacked to the slippers with French knots. Calligraphic letters embroidered in French knots (left, bottom) have a raised, nubby look. You can also make a monogram without embroidery by tracing the outline of a letter onto felt, cutting it out, and gluing or hand-stitching it to the slipper.

If you're new to embroidery, follow these techniques for the satin stitch and French knot: 

Satin Stitch:

At an angle or straight across, these side-by-side stitches fill in the outlines for a shape. Pull the needle through to front at 1. Insert at 2; pull needle back through at 3, right next to 1. Keep stitches tight and flat for a smooth finish.

French Knot:
These are useful for creating a raised point of interest. Pull needle from back of fabric to front at 1. Holding thread taut with one hand, wrap it twice around needle; insert needle again close to 1, keeping thread taut as needle is pulled through to back.

materials

  • Felt or melton wool

  • Transfer paper

  • Embroidery hoop

  • Embroidery floss

  • Needle

  • Scissors

  • Button

  • Buttons (optional)

steps

  1. Draw a circle on a piece of felt or melton wool, then draw a letter in the circle using transfer paper or working freehand.  Remove fabric from hoop, cut out the circle, stretch it over the button (following the instructions from a covered-button kit, available at sewing stores), and catch the edges on the teeth in back. Snap the front of the button to the back half, and sew onto a slipper.

  2. Clip the fabric into an embroidery hoop. With embroidery floss, embroider the letter in satin stitch, French knots, or another favorite stitch.

  3. Remove fabric from hoop, cut out the circle, stretch it over the button (following the instructions from a covered-button kit, available at sewing stores), and catch the edges on the teeth in back. Snap the front of the button to the back half, and sew onto a slipper.

Reviews

Be the first to comment!

Related Topics