Lace-Inset Table Runner

Sew a beautiful lace-inset table runner with a romantic, classic appeal by following these step-by-step instructions.

Lace-Inset Table Runner

Source: The Martha Stewart Show, April 2009


  • Linen fabric, enough yardage for the length of the desired table runner plus 4 inches.

  • Spray starch

  • Iron

  • Pins

  • Measuring tape

  • Scissors

  • Rotary cutter, grid ruler, and self-healing mat

  • 1-inch or wider lace

  • Water-soluble fabric marker

  • Pfaff Creative 2.0 Sewing and Embroidery Machine

  • Coordinating thread

  • Wing needle

  • Applique scissors (optional)

  • Embroidery


  1. Prepare fabric by spraying with spray starch and ironing. Determine the measurements of your runner, and add 2 inches to the width and 4 inches to the length for the hem. Cut fabric to these dimensions.

  2. On the short ends, cut fabric into a 45-degree-angle chevron or "V" shape. Press a 2-inch hem and sew a mitered corner on the chevrons.

  3. Press a 2-inch hem into the two long sides.

  4. With a water-soluble fabric marker, mark a guide line on the front of the runner, 2 inches from the edge of each chevron, and pin lace to front of fabric along these lines.

  5. Attach lace on both sides with a hemstitch, using a wing needle in your sewing machine. This stitch captures the hem on the backside for a clean finish, and the wing needle creates a hole that blends well with the lace.

  6. If you wish, trim the fabric behind the lace with applique scissors to create a lace "window" that shows the tablecloth underneath.

  7. Measure to the center of the chevron and mark with a water-soluble fabric marker; use this as your guide to place embroidered initials with the embroidery arm.


Be the first to comment!